Home Improvement

How high should outlets be in bathroom?

There are no set rules for the height of receptacles on walls or over counters, even in a bathroom. Good practice is to keep them at least 4 inches above a counter top or backsplash and not directly over a sink or under a window.

What height should a bathroom outlet be?

A typical bathroom counter is 32 to 36 inches above the floor. A bathroom counter usually has a 4-inch backsplash, where the counter surface turns up the wall. Backsplashes prevent water from running behind a countertop. An electrical outlet receptacle is usually placed 2 to 3 inches above the top of the backsplash.

Where should an outlet be placed in a bathroom?

Outlet Receptacles

You should keep the receptacle at least 6 feet away from the edge of a bathtub or shower and at least 1 foot away from sinks. Avoid positioning a receptacle over the center of the sink, where cords hairdryers and electric shavers might hang down into the basin.

How high should outlets be above countertop?

20 inches

Receptacle outlets shall be installed so that no point along the wall line is more than 24 inches measured horizontally from a receptacle outlet in that space. Receptacle outlets serving the countertop shall be located above the counter top, but not more than 20 inches above the countertop.

How close can an outlet be to a toilet?

Re: Outlet very near toilet

So they had room to access the outlet … as long as they have a minimum of 15″ from the center line of the toilet to the wall on the short side it meets minimum code requirements.

How close can an electrical outlet be to a water faucet?

According to the National Electric Code, any receptacle within 6 feet of a water source needs to be protected with a GFCI.

Can an outlet be behind a toilet?

Since the electrical cords on bidet seats are about 4 feet long, it’s recommended that new outlets be installed on the wall behind the toilet. Most of the electrical cords extend out from the right hand side of the bidet when facing the toilet, so plan accordingly.

Do all outlets in a bathroom need to be GFCI?

Where Should GFCI Outlets Be Installed? Bathrooms – All bathroom receptacles should have GFCI outlets installed. Garages & Sheds – Any area inside or outside of the house that is not considered a “habitable” room should include GFCI outlets. This includes garages, sheds, and any other work/storage areas.

Can the outlets in a bathroom be on the same circuit as the lights?

No lighting outlets or other equipment can be fed from the same circuit feeding the bathroom receptacles. For example, a one-family dwelling has two bathrooms and a duplex receptacle has been installed in each. One 20-ampere branch circuit can supply power to both bathroom receptacles but cannot feed anything else.

Can you wire two GFCI outlets together?

When you need to wire multiple GFCI outlets such as in a kitchen or bathroom you have a couple of options. To save money, you can put in a single GFCI and then wire additional standard outlets to the “LOAD” output from the single GFCI. This provides the same protection as having a GFCI at each location.

How close can a GFCI outlet be to a shower?

Receptacles shall be installed no closer 3 feet horizontally from, and 8 feet vertically from the top of the bathtub rim or shower stall threshold.

How far does an outlet need to be from a sink?

Every bathroom must have at least one electrical outlet. It must be a GFCI, and it must be within 3 feet of the edge of the sink. Either behind or beside the sink is acceptable — across from the sink on an opposite wall is not. If the bathroom has two sinks, each must have an electrical receptacle within 3 feet.

How close can a light switch be to a bathtub?

Switches must be located not less than 5 feet from pools [680.22(C)], outdoor spas and hot tubs (680.41), and indoor spas or hot tubs [680.43(C)].