Home Improvement

How do you get a clean out plug off?

Soak the cleanout plug threads with rust penetrant. Then smack opposite sides of the tee or wye fitting at the same time using two hammers. Rotate the double blows around the entire fitting. Then try using a pipe wrench again.

How do you remove a cleanout plug?

Loosening a Stuck Cleanout Plug with a Hammer and Chisel

If the plug remains stubborn, place a cold chisel on one edge of the nut and tap it firmly counterclockwise with a ball-peen hammer. Then move to the next face. Continue hammering until the stuck cleanout plug is loose enough to turn with a wrench.

How do you remove a PVC cleanout plug?

Use an adjustable wrench or adjustable pliers to unscrew the clean-out plug from a P-trap. Place a bucket under the trap to catch the water that will spill out when you remove the plug. Turn the plug counterclockwise to remove it, install the replacement, and turn it clockwise to tighten it.

How do you remove a sewer cleanout cap?

Driving a screwdriver at an angle into the outer edge of the cap. Then tapping it with a hammer to pry it open little by little. Directly tapping the fitting on top of the cap with small sledgehammer to get a little bit of movement. Again, if you accidentally break the cap, they are cheap to replace.

How do you remove the cleanout plug on a cast iron floor drain?

But what we're going to do is we're going to heat this up just around the outside edge. Right where the brass meets the cast iron. You're gonna do that evenly around the outside edge.

How do you open P trap cleanout?

But if you find that this is on too tightly you can use channel lock pliers or wrench before I start any job under the sink I like to put on some vinyl gloves. It cuts down on the gross.

Where is the clean out plug in the basement drain?

Homeowners will commonly encounter a cleanout plug when attempting to repair a clogged basement drain or garage floor drain. Beneath the cover of these drains, there is a standard drainage pipe as well as a metal or plastic cap situated off to one side of the pipe.

How do you remove an outside drain cover?

Unblock the Drain

Take your drain rods and push them into your drain chamber. Keep on pushing until you feel yourself dislodge the blockage. Push the drain rod continually through the blockage and this should dislodge and break it up.

How do you open a storm drain cover?

Using a manhole hook, often called a manhole key, to remove manhole covers is a great tool for safely opening the cover. Manhole keys come in a variety of sizes and styles. Make sure to use the correct manhole key for the manhole covers you have in your municipality.

How do you open a sewer drain?

Your step-by-step guide: How to clear a main sewer line clog

  1. Loosen the cap on the drain pipe. …
  2. Allow any sewer buildup to come out of the drain. …
  3. Gently feed the auger cable into the main line drain. …
  4. Run the auger until the clog is broken up. …
  5. Hose out leftover debris. …
  6. Pull the auger cable back out of the main line drain.