How do you change a heater core in a 1993 Ford Ranger?
Page Contents
Replacing the heater core is easy – just disconnect the heater hoses, remove the cover screws under the dash, and pull it out. Reverse for reassembly. You can try to flush the core with it in the vehicle. You didn’t say whether or not you checked why you’re not getting heat.
How do you change a heater core in a 1991 Ford Ranger?
And connect up with the heater core which is inside the cabin. First step drain the coolant out of the radiator and remove these two hoses from the heater core.
How do you remove a heater core and replace it?
Loosen the radiator cap, and place a drain pan under the radiator drain plug or petcock. Remove the plug or open the petcock to drain the coolant. Remove the glove box door or any related parts that are in front of the heater core. Carefully remove any wiring connected to your heater core.
Does a 1994 Ford Ranger have a computer?
This Engine Computer also referred to as an Engine Control Module (ECM), Engine Control Unit (ECU) & Powertrain Control Module (PCM) is a guaranteed replacement for all 1994 Ford Ranger PCM models with a 2.3L engine size.
How do I know if my heater core is inlet or outlet?
Right there the other heater line runs to the bottom of the water pump you can see how it runs here and then takes a sharp duct downwards. That's going to indicate the outlet heater hose.
Does coolant go to heater core?
The heater core has tubes that circulate hot engine coolant through them before the coolant is returned to the radiator. Air blows over the hot coolant to warm it before it’s blown through your vehicle’s vents.
How do I flush my heater core?
Now, here’s how to perform a heater core flush:
Step 1: Locate the Heater Core. …
Step 2: Disconnect the Heater Hoses. …
Step 3: Apply the Pressure. …
Step 4: Hit it with the Hose. …
Step 5: Reconnect the Heater Hoses. …
Step 5a: Flush your entire cooling system with Thoro-Flush. …
